Work out your hose routing and decide where to use each hose end extra hose ends and hose are available.
Mustang ii power rack and pinion pressure port.
Care must be taken that the hoses are hooked up correctly since the braded hose adapters supplied with most hook up.
The diagram shows the general routing of a power steering system.
The kit comes with 90o hose ends.
Because ports are the same thread size the pressure and return hoses can be reversed causing violent self steering and damage to the rack.
The mounting bolts are 5 8 diameter.
High pressure from the pump into the rack the return fitting is 6an.
This video explains plainly which port on the mustang fox body and sn 95 rack and pinions are the high pressure port and which is the low pressure return port.
Some installations may need to use the rack and pinion spacers.
Ford rack pinion units with same size pressure and return ports.
Pressure fitting is 6an.
The high pressure fitting is the m14x1 5 thread port which is toward the front of the rack and the return fitting is m16x1 5 thread port that is at the rear closest to the pinion input shaft.
Care must be taken that the hoses are hooked up correctly since the braded hose adapters supplied with most hook up kits convert both ports to a 6 hose size.
Rack and pinion steering on the other hand is generally.
This power rack has a v style input shaft and uses the same tie rod ends as the mustang ii rack.
Begin the installation by assembling the proper adapters into the pump and rack pinion.
Check here for special coupons and promotions.
Low pressure from rack to reservoir high pressure from pump to rack rack and pinion specifications.
Low pressure from the rack into the reservoir.
The flanged side of the bushing will be towards the crossmember.
Using the 2 mounting bolts and mounting bushings bolt the rack and pinion onto its mount.
The high pressure fitting is the m14x1 5 thread port which is toward the front of the rack and the return fitting is m16x1 5 thread port that is at the rear closest to the pinion input shaft.
Use figures below to determine the pressure port for your part number.
The mounting bolts are spaced 15 1 2 apart.
Most steering gear applications would run between 1 100 1 300 psi with heavy vehicle high demand applications on up to 1 550 1 600 psi.
The pressure port in the rack is the 1 2 20 port.
Order rack pinion complete unit for your 1978 ford mustang ii and pick it up in store make your purchase find a store near you and get directions.
The pressure port is m14 1 5 o ring.
The original rack pinion may have a removable check valve in the.
The return port is m16 1 5 o ring.
Input shaft is 3 4 36 splined shaft.
